Gauntlet cased

Gauntlet now has a case, it's 3D printed and there's a few bits I need to adjust, but for a first go I'm really pleased with it.

The 3D printed knobs and switch covers came out well.
The case is pretty good but I had a bit of under extrusion in one place and fitting the heat inserts is a total nightmare, so I need to improve that too.

And another picture showing the back (below) this time, here you can see I need to move a few parts (power switch, audio jack, etc).

The orange really pops in the sunlight, I love it.

I plan to take it to a few friends, see what they think and if there's things they'd change before I do a revision to the PCB.